Alarm.com ADC-SWM150 Smart Water Valve and Meter
Alarm.com ADC-SWM150 Smart Water Valve and Meter
The ADC-SWM150 is an ingenious addition to your z-wave smart home accessories. This smart water valve + meter is capable of monitoring the main water line coming into your home for leaks and usage throughout the home. Using Alarm.com’s z-wave, you can open or close the valve inside using the Alarm.com app. Rules can be set in place to automatically shut the valve in the event that a leak is detected and can even be paired with a water sensor to automatically shut of the main water supply if that sensor is tripped.
Installation is fairly simple; the ADC-SWM150 ties directly into the main water supply of your home. Along with the main meter and valve unit, the SWM150 has a control unit that connects to the main valve, and from there has a transformer that plugs into your wall. Once installed, it can be paired to your z-wave hub using “add device” in your Alarm.com app. Once connected it allows full water flow monitoring and automatically detects leaks allowing you to monitor the water usage in your home from anywhere.
NOTE: Additional parts required: Installation will require additional fittings to connect the ends of the valve to the pipe. The type of fittings needed will depend on the existing pipe size, material, and threading type as well as applicable plumbing codes.
IMPORTANT: Use of the ADC-SWM150 is dependent on a Commercial or Residential Interactive plan, WITH automation enabled, from Alarm.com.
ADC-SWM150 Installation manual
ADC-SWM150 Data Sheet
IN THE BOX:
-ADC-SWM150 Control Unit
-Brass valve and meter
-Plastic enclosure
-Actuator
-Mounting plate
-Drywall anchors & screws (x2)
-Cable ties (x3)
-Power adapter
-Installation guide
SPECS:
Power – 100-240 VAC (50/60 Hz)
Operating Temperature – 14°F to 185°F (-10°C to 85°C)
Operating Humidity – 0% to 95% non-condensing
Requirements – For indoor use only, Alarm.com system, Expansion tank for water heater
Valve – Size: 1″ – Threads: Male NPT
Control Unit Dimensions – 2.75 x 4.0 x 1.25” (6.99 x 10.2 x 3.18 cm)
Meter and Valve Dimensions (with Enclosure) – 11 x 5.75 x 3.75″ (27.9 x 14.6 x 9.53 cm)
Actuator and Valve Dimensions – 4.5 x 2.0 x 3.75″ (11.43 x 5.08 x 9.53 cm)
Maximum Compatible Pipe Size – 1.25″ (3.175 cm)
Power Supply Cable Length – 19.7’ (6 m)
Plumbing Certifications – ICC-ES-PMG (compliance with NSF 61 and NSF 372), Massachusetts Accepted Plumbing Products Registry
